Alderon Industries WaterPro VA02A Handbuch für Betrieb, Wartung und Installation - Seite 3
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb, Wartung und Installation für Bedienfeld Alderon Industries WaterPro VA02A herunter. Alderon Industries WaterPro VA02A 4 Seiten. Alarm panel
Seite druckenWaterPro
Alarm Panel
™
Model - VA02A
Operation, Maintenance and Installation Manual
Installation of the WaterPro™ Alarm Panel Continued
3. If connecting to an existing alarm security system or BAS system leave terminals "+" and "-" open and use 18 gauage 2
conductor wire to connect the existing product to terminals 1A, 1B, 2A, and 2B (Fig. 8). When connected, replace the access
cover and pull the wire through the knockouts on the access cover (see step 4) .
wires away from sharp objects & internal components.
Terminals "+" & "-"
11.1 VDC, 100mA power supply for use on external equipment
Terminals 2A & 2B
Zone 2 Alarm
Normally Open
Terminals 1A & 1B
Zone 1 Alarm
Normally Open
Class 2, 24 VDC/VAC (50/60 HZ)
500 Milliamps MAXIMUM
4. Use a needlenose pliers to remove the desired "break away tabs" from the access cover (Fig. 9). Lightly pull and twist off
tab(s). Replace access cover and run wires through the "break aways" (Fig. 10).
5. Make note of the alarm condition(s) you are monitoring and keep near alarm.
PO Box 827 Hawley, MN 56549 Phone: (218) 483-3034 Fax: (218) 483-3036 www.alderonind.com
(Fig. 9)
Caution!
- When installing wires, route all
(Fig. 8)
+
-
2A 2B 1A 1B
+
- 2A 2B 1A 1B
1 2 3 4
(Fig. 10)
Page 3 of 4