eControls Comfort 365 C365T11 Handbuch für Installateure - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch für Installateure für Thermostat eControls Comfort 365 C365T11 herunter. eControls Comfort 365 C365T11 8 Seiten.

Seite drucken

SEPARATE THE C365 SUBBASE

Place a slotted screwdiriver in the slots as shown and rotate to

remove subbase from the C365 housing.

ATTACH THE SUBBASE TO THE WALL

Attach the subbase to an interior wall and about 5-feet above

the floor as shown using the screws and wall anchors supplied.

The wires to the dampers, HVAC equipment and the upstairs

temperature sensor pass through the opening between the

terminals.

U p s ta

ir s

S e n s

o r

INSTALL TWO AA BATTERIES

The batteries power the clock when 24VAC power is lost. Slide

the battery cover downward and install the two AA batteries as

shown.

INSTALL UPSTAIRS & DOWNSTAIRS DAMPERS

Install an R80CT damper in the duct supplying air to the upstairs

and wire the terminals to the corresponding terminals on the

C365T. Install a second R80CT damper in the duct supplying air

to the downstairs and wire it to the C365T. Each damper uses

2.4VA of power.

When two or more dampers are required to define the upstairs or

C O M

downstairs zones, the damper may be wired in parallel. LEDS

C L S

on the damper actuator indicate when the damper is fully open

O P N

C O M

(green) or fully closed (red).

C L S

O P N

U p s

t a ir s

S e n

s o r

Green LED

Red LED