eControls Comfort365 C365T21 Installer And User Manual - Seite 2

Blättern Sie online oder laden Sie pdf Installer And User Manual für Thermostat eControls Comfort365 C365T21 herunter. eControls Comfort365 C365T21 13 Seiten.
Auch für eControls Comfort365 C365T21: Installer And User Manual (13 seiten), Benutzerhandbuch (4 seiten)

Seite drucken

Replacing Thermostat Document installer options if

settings are different than factory defaults.

After installing and wiring dampers and sensors to the

thermostat, CHECK FOR ERROR MESSAGES (p.4)

Set time of day (p.4)

Set Options 1-7 (p.5-7) for equipment operation if

different than Factory Settings.

Disabling Airflow Control Turn Airflow Control Off

using Option 17. The thermostat will control the system

just like any other thermostat. Dampers fully open,

nighttime airflow options are disabled and airflow is no

longer displayed on the thermostat

AND COMPLETELY BEFORE PROCEEDING WITH INSTALLATION.

Turn off all power to the HVAC system before wiring or installing Comfort365 components.

SEPARATE THE C365 SUBBASE

Place a slotted screwdiriver in the slots as shown and rotate to

remove subbase from the C365 housing.

ATTACH THE SUBBASE TO THE WALL

Attach the subbase to an interior wall and about 5-feet above

the floor as shown using the screws and wall anchors supplied.

The wires to the dampers, HVAC equipment and the

temperature sensor pass through the opening between the

terminals.

ATTENTION INSTALLER

READ THESE INSTRUCTIONS CAREFULLY

C O M

C L S

N C

O P N

T S

C O M

C L S

O P N

T S

User Airflow Control enables the user to control the

airflow rather than the thermostat automatically

controlling the airflow. Installer must enable Option 18

and the user must turn off automatic airflow in the

User Options. The Nighttime Airflow Control is still

enabled, but can be turned off using User Options.

Nighttime Airflow Control is defaulted to On. If

bedrooms are located downstairs, consider turning off the

Nighttime Airflow Option using the User Options.

Go to www.eControlsUSA.com/contractor for installer

resources.

INSTALL TWO AA BATTERIES

The batteries power the clock

when 24VAC power is lost.

Slide the battery cover

downward and install the two

AA batteries as shown.

INSTALL SLEEPING AND LIVING AREA DAMPERS

Install an R80CT damper in the duct supplying air to the

sleeping area and wire the terminals to the corresponding

terminals on the C365T21. Install a second R80CT damper in

the duct supplying air to the living area and wire it to the

C365T21. Each damper uses 2.4VA of power.

Ensure that damper installation does not cause

obstruction to the damper blade.

When two or more dampers are required to define the sleeping

or living area, the dampers may be wired in parallel. LEDS on

the damper actuator indicate when the damper is fully open

(green) or fully closed (red).

Green LED

Red LED