eControls FC3JU Handbuch für Hausbesitzer und Installateure - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Hausbesitzer und Installateure für Zeitschaltuhr eControls FC3JU herunter. eControls FC3JU 8 Seiten. Wall timer control kit

Seite drucken

Wiring FC3JU to 2-Speed ECM WHF

For 2-speed ECM WHFs, the yellow wire is not used and

should be cut off at the PC board. Use wire nuts to connect the

FC3JU wires to the WHF wires and the incoming 120VAC

power wires. Orient the FC3JU and electrical box as shown.

Model FC3JU

FC3JU Wire

Connects

High Speed (Purple)

WHF High Speed

Med Speed (Yellow)

Not Used.

WHF Low Speed

Low Speed (Red)

Neutral (White)

WHF Neutral and

120VAC Neutral

Ground (Green)

WHF Ground and

Power Ground

120VAC (Black)

Power 120VAC

Install the WT3 Wall Timer

Find a suitable location for the wall timer, typically in the

bedroom area. Run the low voltage plug&play cable to

the wall timer location and connect to the WT3.

The WT3 can be installed in a

single gang box or directly to

the wall using the hardware

provided.

An extension cable, Model

PNP25C, is available if you

need more than 25' length.

WT3

Timer/Speed

Control

INSTALLATION

Use wire nuts to connect the FC3JU wires to the WHF wires

and the incoming 120VAC power wires. Orient the FC3JU and

electrical box as shown.

Electrical box on WHF

Ground

screw

Power

Cord or

Romex

The WT3 and FC3JU are connected using the 25-foot

RJ11 cable provided. One end of the cable should

already be connected to the WT3. Plug the other end of

the cable into the FC3JU.

25-foot P&P

Cable supplied.

Use template

in Manual

as guide

Wall anchors

Wiring FC3JU to 3-Speed ECM WHF