aerauliqa QR590E Installationshandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Installationshandbuch für Fan aerauliqa QR590E herunter. aerauliqa QR590E 20 Seiten. Energy recovery ventilation unit with enthalpic heat exchanger
Seite drucken
User menu
1 Mode Selection
2 Boost
3 Boost Duration
4 Reset FILTER Alarm
5 Night Mode
6 Installer menu
Mode selection
3V
Mode selection
OFF
Mode selection
Holiday
User menu
1 Mode Selection
2 Boost
3 Boost Duration
4 Reset FILTER Alarm
5 Night Mode
6 Installer menu
User menu
1 Mode Selection
2 Boost
3 Boost Duration
4 Reset FILTER Alarm
5 Night Mode
6 Installer menu
User menu
1 Mode Selection
2 Boost
3 Boost Duration
4 Reset FILTER Alarm
5 Night Mode
6 Installer menu
10
Mode selection allows the choice among 3V (three speed), OFF and HOLIDAY mode.
Press OK to enter.
Use or to choose the mode.
Press OK to select.
Press ESC to go back to the previous menu.
3V mode (DEFAULT)
3V is flashing: press OK to select.
Once powered on, the unit runs at speed 1.
Press ESC or wait for about 60 sec to go back to the operation screen (Fig. 7.c).
In case of activation of either HY or IAQ sensor inputs (OR logic), the unit speed increases
by 15%, and the sensor related icon or is displayed. Once all on/off sensors inputs
are deactivated, the unit reverts back to selected speed.
In case the user has activated the NIGHT MODE , during nocturnal hours (from 8:00
p.m. to 8:00 a.m - fixed period of time) the sensor logic described above is ignored (the
sensors have no effect and the unit runs at selected speed).
OFF mode
OFF is flashing: press OK to select.
The fans are switched off (the power supply to the motors is interrupted).
Press ESC or wait for about 60 sec to go back to the operation screen: OFF is displayed.
HOLIDAY mode
Holiday is flashing: press OK to select.
The unit works at HOLIDAY speed.
Press ESC or wait for about 60 sec to go back to the operation screen.
It allows to select the Boost speed.
Press OK to select.
Choice NO or YES using or .
Press OK to select.
Boost speed can be selected only if the Mode selection is 3V or HOLIDAY.
Boost function can be activated in these ways:
- In the user menu, with the Boost function
- via the BOOST button on the CTRL-DSP (Fig. 7.b - )
- Using a momentary switch connected to the BST ON/OFF (only if no dehumidifier is
installed) - Fig. 5.g.
When Boost is active, the icon
speed for the duration set in the "Boost duration" menu; afterwards the unit reverts to
selected speed.
Boost can be deactivated by holding BOOST button on the CTRL-DSP for 2 seconds.
It allows to set the duration of the boost speed.
Press OK to select.
The factory setting (DEFAULT) is 15'.
Time options are 15' - 30' - 45' - 60'.
Time is flashing: use increase the time and to decrease.
Press OK to select.
It allows to reset the filter alarm after maintenance/replacement.
It can be selected only if the FILTER icon is displayed (Fig. 7.b - ).
Press OK to select.
K
is displayed on the LCD and the unit runs at 100%
I