DirectBikes DB125T-13 Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Scooter DirectBikes DB125T-13 herunter. DirectBikes DB125T-13 18 Seiten.

It is important you do not 'cross thread' the mirror as

it will damage the mount. When the mirror is in as

far as it will go sit on the motorcycle and make sure

you can see behind you. Once done move the lock

nut down and tighten being careful not to over

tighten. Finish by sliding the rubber boot down over

The battery supplied is a SEALED lead acid type.

Please wear protective clothing at all times when

assembling the battery. If spilled rinse the area

Place battery on level ground out side. Using blister

pack of acid supplied, turn upside down and put

onto the top of the battery. The six foil seals should

locate accordingly with the 6 cells of the battery.

Push the blister pack down so that the seals are

broken. Leave the acid to drain into the battery.

Once all of the acid has drained into the battery,

remove the blister pack and discard appropriately.

Remember there may still be small amounts of acid

inside it. Let the battery stand for 20 minutes. Make

sure that the acid is covering the plates. If needed

top up with distilled water. Place the sealing cap

onto the battery and push down evenly till the cap is

flush. Now wash any spillages off the battery.

The battery should be charged at 1/10 of its

capacity for 10 hours. For example if it is a 12 volt 7

amp hour (12v7ah) battery it should be charged at

0.7 amps for 10 hours. Do not use a car charger as

they often have 4 to 10 amps output and will

the lock nut.

Filling the battery

immediately with water.

Charging of the Battery