Yamaha DTX520K Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musikinstrument Yamaha DTX520K herunter. Yamaha DTX520K 48 Seiten. Dtx drums
Auch für Yamaha DTX520K: Montageanleitung (2 seiten), Montageanleitung (2 seiten)

Seite drucken

Connections

In this chapter, you'll learn how to set up the DTX500. Read these instructions carefully and in

the following order to ensure that the instrument sounds and operates properly:

1 Connecting the Pads → 2 Setting Up the Power Supply (p. 10) → 3 Connecting to Speakers or Head-

phones (p. 10) → 4 Turning the Power On (p. 11) → 5 Selecting the Trigger Setup (p. 12)

You'll need to change the Trigger Settings of the DTX500 according to the type of drum set you are using. If the

setting is not appropriate, problems may occur—such as improper sound, or inappropriate volume balance

among the pads.

Refer to the "Selecting the Trigger Setup" section on page 12 on how to select the appropriate setup.

1 Connecting the Pads

Referring to the illustration below, connect the output cable from

each pad to each Trigger Input jack located on the rear panel of

the DTX500. For details, see the Assembly Manual that comes

with the drum set you are using.

CAUTION

• To prevent electric shock and damage to the devices,

make sure the power is switched OFF on the DTX500 and

all related devices before making any connections to the

DTX500's input and output jacks.

Setting up with Acoustic Drums

The DTX500 can be played from an acoustic drum kit if the kit is

ﬁtted with an optional set of drum triggers (such as Yamaha DT20

Drum Triggers) and the triggers are properly connected to the

input jacks of the DTX500.

2 Setting Up the Power Supply

A special power source adaptor supplies power to the DTX500.

2-1. Make sure that the

set to the standby (?) position.

2-2. Connect the DC plug of the included AC power adaptor to

the DC IN terminal on the rear panel.

To prevent the cord from being unplugged accidentally,

wrap the cord around the cable clip and secure it.

DTX500 Owner's Manual

!! IMPORTANT !!

Standby/On Switch of the DTX500 is

CAUTION

• Make sure that the power adaptor's cord is not bent at an

extreme angle when wrapping the cord around the clip.

Doing this can damage or sever the cord and create a ﬁre

hazard.

2-3. Connect the other end of the power cord to an AC outlet.

WARNING

• Please use the speciﬁed AC power adaptor. The use of

any other adaptors may cause irregular operation or

damage to the device.

• Only use the voltage speciﬁed as correct for the DTX500.

The required voltage is printed on the name plate of the

DTX500.

CAUTION

• Unplug the AC Power Adaptor when not using the

DTX500, or during electrical storms.

3 Connecting to Speakers or

Headphones

Since the DTX500 has no built-in speakers, you'll need an exter-

nal audio system or a set of stereo headphones to properly moni-

tor it.

Monitor system for the DTX series

MS100DR, MS50DR, etc.

OUTPUT L/MONO and R jacks

Headphones

PHONES jack