Yamaha S90 ES Kurzanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Kurzanleitung für Musikinstrument Yamaha S90 ES herunter. Yamaha S90 ES 11 Seiten. Half damper function and damper resonance effect
Auch für Yamaha S90 ES: Schnellstart-Handbuch (4 seiten)

Seite drucken

active when you initially call up a Voice is a

function of the [CONTROL FUNCTION] section and

is programmable per Voice. When set to VOL, as

below, the Sliders will send System Exclusive

messages to control the Element levels within the

Voice. (When selected in a Performance the

Sliders control Voice levels with the Performance).

When in a MASTER Setup you will most likely

select ZONE as the active row making the Sliders

then programmable per Master setup.

Control Sets Summary: Each AWM2 (sample-

based) S90 ES Voice has six Control Setups where

physical

controller,

assigned a specific controllable parameter, called

the Destination (DEST) and a Depth value that

determines how much effect the controller will

have. This flexible system will enable the user to

tailor

the

sensitivity

movement. Sensitivity or Depth refers to how far

you move the controller to get a desired result.

This is an important setting because you want to

be comfortable working the controller while you

perform.

The destinations are listed in detail on page 36 of

the Data List booklet that comes with your S90

ES. They include Voice volume, reverb send,

chorus

send,

and

some

parameters (not all Insertion Effect parameters

are real time controllable). And if you are dealing

with the internal sample-based Voices, an array of

Common and individual Element parameters like

filter cutoff, resonance, LFO speed and depth,

tuning, key on delay, Pan position, Pitch, Filter

and Amplitude envelopes, etc., etc., can be

programmed. PLG1, PLG2 and PLG3 Voices will be

able to be assigned to volume, reverb send,

chorus send and the 26 possible Insertion Effect

parameters, only.

Each PLG-series board may have controller sets of

their own, depending on the technology involved –

these will be programmed in the PLG Voice Editor

software. For example, if you program (using the

provided AN Expert Editor) a PLG150-AN Voice to

respond to cc16 for filter cutoff and cc17 for filter

resonance, it will have its 'virtual analog' filter

controlled by the S90 ES Assign 1 / 2.

Note: PLG150-series Plug-in Voices will have a

different set of Controller Set screens in the S90

called

the

Source,

each

controller's

Insertion

Effect

ES (explained below). Also, look in the Voice

Editors

for

routings. For example, the PLG150-AN has some 8

AC (assignable control devices) and 15 Control

Sets available. The PLG150-AN is based on the

AN1x keyboard synth, which had 8 front panel

assignable knobs AC1-AC8. You can reassign as

many as you wish to your available S90 ES

physical controllers. Each board will have a

different controller setup arrangement depending

on the technology involved.

PLG150 Series boards are single PART boards and

have two kinds of Voices: PLUG-IN and BOARD.

PLUG-IN

Voices

integrated with S90 ES Effects and Controller

routings (discussed below). BOARD Voices are

resident on the Board itself and have not yet been

integrated with the host parameters (hopefully

you will customize them to your liking). Each

board comes with a different amount of Board

Voices for you to build PLUG-IN Voice and the S90

ES gives you 64 blank USER locations for you to

place them.

The

PLG150

additional Controller (CTL) screens that will let

you route controllers to the following areas:

Modulation Wheel Assignment: In each S90 ES

PLG150 Voice you can assign MW to directly

control

the

Modulation (PMod) – vibrato; Filter Modulation

(FMod) – wah-wah; and Amplitude Modulation

(AMod) - tremolo.

Aftertouch

assigned

Amplitude Mod and the direct control of Pitch with

(AT) key pressure

Assignable Controller: For each PLG150 Voice

you will find a screen for an Assignable Control –

AC Control. Here you can pick a device (physical

controller) or control change number to do various

tasks: Control the Filter, Pitch Modulation, Filter

Modulation, and Amplitude Modulation. These will

enable the user to customize routing for the

PLG150 Voices.

additional

assignable

are

those

that

Voices

will

have

the

Filter

(cutoff/resonance);

Assignment:

Aftertouch

Filter,

Pitch

Mod,

controller

have

been

following

Pitch

can

Filter

Mod,