Yamaha TP-7300Rseries Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musikinstrument Yamaha TP-7300Rseries herunter. Yamaha TP-7300Rseries 14 Seiten. Pedal timpani

Seite drucken

Lightly strike the head with the mallet about 2

inches (5 cm) from the bearing edge at each

tension rod. Check which tension rod has the

highest sound.

• Pitch of the highest sound is higher than

the tuning note (*)

g Loosen the corresponding tension rod by

about 1/16 to 1/8 of a turn. First loosen

the bolt by twice the desired amount, and

then return (re-tighten) it by half. After

loosening the tension rod, repeat from the

beginning of step

• Pitch of the highest sound is lower than

the tuning note

g Go to step

Tighten the other bolts little by little (by about

1/16 to 1/8 of a turn) until the sounds at the

corresponding striking points match the pitch of

the highest sound. Please note that tightening

one bolt also raises the pitch of the neighbor-

ing and opposite tension rods. Thus, after tight-

ening the tension rod with the lowest sound,

again check the pitch at the other tension rods

before tightening the tension rod with the next

lowest pitch. While alternately tightening the

other bolts, do not touch the tension rod with

the highest pitch (reference pitch).

Loosen all over-tightened bolts according to

the procedure described in step

the pitch is approximately the same at each

bolt, repeatedly depress the toe and heel of the

pedal several times.

Repeat steps

through

each bolt is exactly the same.

(*). When

until the pitch at

Check the sound by striking the head as de-

scribed in step

• Sound is lower than the tuning note

g Tune the instrument by tightening all ten-

sion rods by an equal amount (max. 1/16

of a turn).

• Sound is higher than the tuning note

g Tune the instrument by loosening all ten-

sion rods by an equal amount (max. 1/16

of a turn) according to the procedure de-

scribed in step

Operate the pedal as described in step

pitch does not change, the instrument is tuned

properly.

(If the pitch changes, repeat from step

The instrument is now tuned to the lowest note

of its tonal range. Depress the toe of the pedal

to change to a higher note.

After tuning, perform "Tuning Indicator Ad-

justment" and then "Pedal Adjustment".

Adjusting the Pitch

(*).

. If the