Yamaha TP3326 Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musikinstrument Yamaha TP3326 herunter. Yamaha TP3326 12 Seiten. Tp3300 series pedal timpani

Seite drucken

1. Pedal Adjustment

Tuning Indicator Adjustment

The tuning indicator shows where to set the pedal for each note. After tuning the instrument, you must

set each note on the indicator to its proper position.

After you have tuned your timpani to the lowest

note of its tonal range, make sure that the pointer

is located within 2~3 mm from the pedal-side end

of the indicator rail.

* If not, refer to "Adjusting the Pointer Position" .

Slide the lowest note of the indicator ("C" in the

case of a 23" timpani*) to the position where its

center line coincides with the pointer.

* "Standard Tonal Ranges for Yamaha Tim-

pani" on page 8.

Tune the instrument to the next higher pitch (note)

by moving the pedal, and then slide the corre-

sponding note on the rail to the respective pointer

position. Repeat for each remaining note.

Indicator Rail

Note

Pointer

l Relocating the Tuning Indicator

The timpani is shipped with a universal style tun-

ing indicator already attached however, the tun-

ing indicator can be relocated for German style

tuning.

Using the supplied hex wrench, remove the two

bolts holding the tuning indicator in place as

shown in the diagram right, then slide the bolts

through the holes on the tuning indicator from the

opposite side. In either position, make sure that

the note indicator bridge is easily viewable.

n Adjusting the Pointer Position

First loosen the pointer lock nut and then turn the ad-

juster as follows:

• Pointer is located beyond the lower rail end

when the heel of the pedal is lowered fully

(lowest note).

→ Turn the adjuster to the left (counter clock-

wise) until the pointer is aligned with the low-

est note of the indicator.

• Pointer moves beyond the upper rail end be-

fore the toe of the pedal reaches the end of its

stroke, or Pointer does not reach the lower rail

end when the heel of the pedal is lowered fully

(lowest sound)

→ Turn the adjuster to the right (clockwise) to

correct the pointer position as required.

Pointer Lock Nut

Universal Style

Attachment

Tuning

Indicator Bolt

Mounting Bracket

Note

Adjuster Cover

* Replace the

cover after

adjusting.

Adjuster

German Style

Attachment

Tuning

Indicator Bolt