Yamaha HTR-5130 Benutzerhandbuch - Seite 22

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Empfänger Yamaha HTR-5130 herunter. Yamaha HTR-5130 42 Seiten. Natural sound av receiver

Seite drucken
Yamaha HTR-5130 Benutzerhandbuch
From page 22 to 38, this manual describes how to operate this unit mainly by using the front panel control parts.
To operate this unit on the remote control transmitter, use the corresponding keys on the remote control transmitter.
TO PLAY A SOURCE
1
28
40
60
Set VOLUME to the minimum level (–
2
Turn the power on.
3
Select the desired input source by using the input
selector buttons.
(For video sources, turn the TV/monitor ON.)
TUNER
* The name of the selected input source will appear on
the display.
4
Select the main speakers to be used.
* If you use two main speaker systems, press both the
A and B switches.
22

BASIC OPERATIONS

2
4
VOLUME
l6
20
l2
8
4
4
2
0
–dB
dB).
STANDBY/ON
TAPE/MD
CD
PHONO
MONITOR
SPEAKERS
A
B
ON
OFF
3
L
R
7
5
Play the source. (For detailed information on tuning
operations, refer to page 26.)
6
7
If desired, adjust BASS, TREBLE and BALANCE (refer
to page 25), and/or use the digital sound field
processor. (Refer to page 36.)
Notes on using the input selector buttons
Note that pressing each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
The selection of TAPE/MD MONITOR cannot be canceled
by pressing another input selector button. To cancel it, press
TAPE/MD MONITOR again so that the TAPE MON indicator
disappears from the display.
When you select a button other than TAPE/MD
MONITOR, make sure that the TAPE MON indicator is not
illuminated on the display.
If you select the input selector button for a video source
without canceling the selection of TAPE/MD MONITOR, the
playback result will be the video image from the video
source and the sound from the audio tape (or MD, etc.).
Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
When you finish using this unit
Press the STANDBY/ON switch on the front panel again or the
POWER
/I key on the remote control transmitter to put this
unit in the standby mode.
1, 6
VOLUME
l6
20
l2
28
8
4
40
4
60
2
0
–dB
Adjust to the desired output level.