Yamaha RP-U200 Benutzerhandbuch - Seite 21
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Empfänger Yamaha RP-U200 herunter. Yamaha RP-U200 33 Seiten.
Seite drucken
ADVANCED OPERATION
Adjusting the speaker balance
This procedure lets you adjust the sound output level balance between the front, center and surround speakers by using the
built-in test tone generator. Make this adjustment so that each speaker output level is almost the same when heard at the
listening position. This is important for high performance of the built-in DSP (Digital Sound field Processor), the Dolby Digital
decoder and the DTS decoder.
If this unit is set in the "Virtual 3D" mode (the surround speakers are not used) on the Application Software, you can adjust
sound output levels of the speakers in the sound field of the "Virtual 3D" mode (including two virtual rear speakers). Refer to
"Setting adjustment on the Setup panel" on page 27. This setting cannot be made by using the front panel and the remote
control.)
* Use the remote control for adjusting output levels of the speakers at the listening position.
POWER
PC
AUX1
AUX2
TUNER
MEMORY
PRESET
MANUAL
HALL
JAZZ
CHURCH
GAME
MOVIE
/ D T S
SURROUND
TEST
A
B
MUTE
VOLUME
1
Press the TEST key on the remote control.
TEST
* You will hear a test tone (so called pink noise) from each
speaker for about two seconds in the following order.
Front speaker (L)
Center speaker
Virtual rear speaker (L)
* The speaker currently outputting the test tone is shown
on the display.
LIVE
ON/OFF
1, 5
C
2, 3, 4
Remote control
Front speaker (R)
Virtual rear speaker (R)
2
When the test tone is outputted from the left (L ch)
or right (R ch) front speaker:
Using the VOLUME keys on the remote control
adjusts the volume of each speaker.
In this step, adjust the volume balance between the left and
right front speakers.
(Adjustable range: –10 to 0)
VOLUME
3
When the test tone is outputted from the center
speaker (Cch):
Using the VOLUME keys on the remote control
adjusts the center speaker output level.
Make the sound output level at the center speaker almost
the same as the left or right front speaker.
(Adjustable range: –20 to +10)
VOLUME
4
When the test tone is outputted from the left (Ls
ch) or right (Rs ch) surround speaker:
Using the VOLUME keys on the remote control
adjusts the volume of each speaker.
Make the sound output level at the surround speakers
almost the same as the front speakers.
(Adjustable range: –20 to +10)
VOLUME
5
When adjustments are finished, press the TEST
key.
TEST
Test tone stops.
ADVANCED OPERATION
Remote control
Remote control
Remote control
Remote control
19
E-