Yamaha AP-U70 Setup-Handbuch - Seite 13
Blättern Sie online oder laden Sie pdf Setup-Handbuch für Verstärken Yamaha AP-U70 herunter. Yamaha AP-U70 47 Seiten. Personal amplifier
Auch für Yamaha AP-U70: Service-Handbuch (46 seiten)
Seite drucken
Make the following settings on your computer after the installation of the driver is finished.
Setting of Audio and Audio CD
[Windows 98/98SE only]
* Terminate all the activated applications.
* When using Windows 98SE, restart Windows, first.
1
Click the Windows "Start" button and select
"Settings", and then "Control Panel".
2
Double-click the "Multimedia" icon.
3
Click the "Audio" tab and select "USB Audio
Device" at "Preferred device" of "Playback".
* Usually, this setting is automatically made.
* If "USB Audio Device" does not appear, restart
Windows.
4
Click the "CD Music" tab and select the CD-ROM
drive for playing audio CDs.
5
Click the check box of "Enable digital CD audio for
this CD-ROM device" to enter the check mark.
* It may happen that the check box cannot be clicked
because some CD-ROM drives cannot be used for
playing audio CDs.
6
Click "OK" and close the "Multimedia" setting
panel.
7
Restart Windows.
Note
When using two or more drives, you must make the above setting
for each drive.
Checking the Audio setting
[Windows Me only]
1
Click the Windows Me "Start" button and select
"Settings", and then "Control Panel".
2
Double-click the "Sounds and Multimedia" icon.
3
Click the "Audio" tab and select "USB Audio
Device" at "Preferred device" of "Sound
Playback".
* Usually, this setting is automatically made.
* If "USB Audio Device" does not appear, restart
Windows.
INSTALLING USB DRIVER AND APPLICATION SOFTWARE
Checking sound output and adjusting volume
[Windows 98/98SE and Windows Me]
USB
PC
AUX1
AUX2
VIRTUAL
5.I
CH
DIGITAL
USB PCM
D. DSP
PROLOGIC FM AM ST
VOL
DSP
M U T E
1
Make the following operations on the front panel of
this unit.
a) Press the power switch to turn on this unit.
(Some messages are shown on the display.)
b) Press the USB input selector key.
c) Use the volume control to adjust the volume.
(Set the control to about "30".)
2
Adjust the volume on the computer as follows.
a) Double-click the speaker icon on the task tray,
or select "Start", "Programs", "Accessories",
"Entertainment" in this order and click "Volume
Control".
(The volume adjustment window appears.)
b) Adjust the volume by dragging the "Volume"
slider. Set the slider between the center and
max. positions.
* Do not enter the check mark in the "Mute" check
box. If entered, sound output will stop.
3
Click the Windows "Start" button and select
"Settings", and then "Control Panel".
4
Double-click the "Sounds" (or "Sounds and
Multimedia") icon.
5
Click the "Sounds" tab.
6
Check that the sound is output normally by
outputting "Default sound", etc. from "Events" (or
"Sound Events").
* If no sound is heard, restart Windows and check again.
USB
Display
Volume control
Power switch
11
E-