Yamaha AX-470 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Yamaha AX-470 herunter. Yamaha AX-470 14 Seiten. Natural sound stereo integrated amplifier
Auch für Yamaha AX-470: Service-Handbuch (24 seiten)

Seite drucken

CONNECTING SPEAKERS

Connect the SPEAKERS terminals to your speakers with wire

of the proper gauge, cut as short as possible. If the

connections are faulty, no sound will be heard from the

speakers. Make sure that the polarity of the speaker wires is

correct, that is, + and – markings are observed. If these wires

are reversed, the sound will be unnatural and will lack bass.

Do not let the bare speaker wires touch each other and do

not let them touch the metal parts of this unit as this could

damage this unit and/or speakers.

How to Connect:

Red: positive (+)

Black: negative (–)

ABOUT THE ACCESSORY TERMINALS

AC OUTLETS (SWITCHED)

Except Australia, U.K. and Europe models of

AX-470

Use these to connect the power cords from your components

to this unit.

The power to the SWITCHED outlets is controlled by this unit's

POWER switch or the provided remote control transmitter's

POWER key. These outlets will supply power to any

component whenever this unit is turned on.

The maximum power (total power consumption of

components) that can be connected to the SWITCHED AC

OUTLETS is 100 watts.

REMOTE CONTROL (PHONO) connector

If you have a YAMAHA turntable with a terminal for remote

control, connect it to this connector by using the cable

provided with the turntable. This connection allows you to

control the turntable from the provided remote control

transmitter.

GND terminal (For turntable use)

Connecting the ground wire of the turntable to this terminal will

normally minimize hum, but in some cases better results may

be obtained with the ground wire disconnected.

Unscrew the knob.

Insert the bare wire.

[Remove approx. 5mm

(1/4") insulation from

the speaker wires.]

Tighten the knob and

secure the wire.

One or two speaker systems can be connected to this unit.

If you connect only one speaker system, connect it to either

the SPEAKERS A or B terminals.

Use speakers with the specified impedance shown on the

rear of this unit.

Banana Plug connections are also possible (except for

Scandinavian models). Simply insert the Banana Plug

connector into the corresponding terminal.

PRE OUT/MAIN IN terminals

For AX-570 only

Removing the jumper pins enables this unit to independently

perform the functions of a control amplifier and a power

amplifier. These terminals are for connection of a signal-

processing system such as a graphic equalizer or sound

processor.

If a sound processor or other component is connected, the

VOLUME control of this unit can be used for overall

adjustment of the level of sound. To connect such a unit,

remove the jumper pins from the PRE OUT/MAIN IN

terminals, connect the inputs of that unit to the PRE OUT

terminals and its outputs to the MAIN IN terminals. For details,

refer to the owner's manual included with the unit to be

connected.