Yamaha DSP-A592 Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Yamaha DSP-A592 herunter. Yamaha DSP-A592 34 Seiten. Natural sound av amplifier

Seite drucken

Note

Use speakers with the specified impedance shown on the rear

of this unit.

Note on main speaker connections:

One or two speaker systems can be connected to this unit. If

you use only one speaker system, connect it to either the

SPEAKERS A or B terminals.

Note on a subwoofer connection:

You may wish to add a subwoofer to reinforce low frequencies.

Connect the SUBWOOFER OUTPUT terminal of this unit to

the INPUT terminal of the subwoofer amplifier, and connect the

speaker terminals of the subwoofer amplifier to the subwoofer.

With some subwoofers, including the Yamaha Active Servo

Processing Subwoofer System, the amplifier and subwoofer

are in the same unit.

How to Connect:

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are

faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and –

markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.

Caution

Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage

this unit and/or speakers.

For connecting to the MAIN SPEAKERS terminals

Red: positive (+)

Black: negative (–)

General model only

Banana Plug connections are also possible. Simply insert the

Banana Plug connector into the corresponding terminal.

(SURROUND)

Unscrew the knob.

Insert the bare wire.

[Remove approx. 5mm

(1/4") insulation from

the speaker wires.]

Tighten the knob and

secure the wire.

Note on center speaker connection:

One or two center speakers can be connected to this unit. If

you cannot place the center speaker on or under the TV, it is

recommended to use two center speakers and place them on

both sides of the TV to orient the center sound at the center

position. For connecting two center speakers, follow the

method shown below.

DSP-A592

REAR

CENTER

DUAL

SINGLE

Center speakers

For connecting to the REAR and CENTER SPEAKERS

terminals

Red: positive (+)

Black: negative (–)

MAIN LEVEL switch

Normally set to "0 dB". If desired, you can decrease the

output level at the MAIN SPEAKERS terminals by 10 dB by

setting this switch to "–10 dB".

DSP-A492