DirectConnect VC70DSW Anweisungen

Blättern Sie online oder laden Sie pdf Anweisungen für Controller DirectConnect VC70DSW herunter. DirectConnect VC70DSW 2 Seiten. 12 step 70w impedance & non-impedance stereo volume control

Seite drucken

INSTRUCTIONS

12 Step 70W Impedance & Non-Impedance Stereo Volume Control

Model: VC70DSW

SKU# .3847

Features:

•

Stereo volume control with selectable impedance and

non-impedance matching-

1X, 2x, 4x, 8x, 16x

•

Covers prepackaged with decorator or standard white

plates.(Optional color kit plates available in ivory,

almond and brown)

•

Power handling: 25 ~ 150 watts per channel RMS

•

12 step Volume Control

•

Removable connectors accommodate 14 – 22 gauge

wire

•

Two sided terminal connector

Instruction

1. Remove about 1/4" of insulation from the ends of all wires to be connected to the volume control and twist the

exposed strands.

2. Loosen the set screws on the volume control connecting blocks.

3. Connect the leads from AMPLIFIER to the set screws on the volume control labeled INPUT, with the LEFT L(+)

and L(-) and RIGHT R(+) and R (-) wires inserted in the appropriately marked opening. Tighten the screws

firmly.

Connect SPEAKER wires to the set screws on the volume control labeled OUTPUT, observing + (positive) and

- (negative)polarity of left and right speaker.

5. Set up the completed assembly in the junction box. Insert carefully to avoid excessive strain on the set screws. If

necessary, pre-dress the wires for easiest mounting.

7. Mount VC into wall box. Insert carefully to avoid excessive strain on these screws.

8. Screw on trim plate and attach knob.

Caution: Be careful not to allow speaker wire strands to short out against case or other speaker wire.

DirectConnect

4747 Westpark Houston, TX 77027

Tel: 800-531-3224

Fax: 713-525-3220