Yamaha XMV4280-D Benutzerhandbuch - Seite 17

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Yamaha XMV4280-D herunter. Yamaha XMV4280-D 42 Seiten. Power amplifier
Auch für Yamaha XMV4280-D: Benutzerhandbuch (43 seiten)

Seite drucken

1. Loosen terminal screws.

Loosen.

NOTE

A slotted screwdriver with a blade width of about 3 milli-

meters is recommended.

3 mm or less

2. Insert cables.

3. Securely tighten terminal screws.

Pull the cables (not too strongly) to confirm that they are

securely connected.

4. Bundle the cables and the Euroblock tab

using the supplied cable tie.

NOTE

Trim any excess part of the cable tie as necessary.

5. Insert the Euroblock plug into the Analog

input connector of the device.

Slotted screwdriver

Terminal screw

Euroblock plug

Tab

+ –



Making Settings for Speaker Output

Use the rear panel [SPEAKERS] DIP switches to make the

appropriate settings for the XMV's speaker output.

The method of connection will differ depending on whether

you're using a low impedance connection or a high imped-

ance connection.

Low-impedance connection

8Ω/4Ω

High-impedance connection

Speaker transformer

70V/100V

10W

For details, refer to "High-impedance and Low-impedance

Connections" (page 30).

The explanation of the settings is divided into the following

sections.

 When using low impedance connections (page

17)

 When using low impedance connections with

Double Power mode (page 18)

 When using high impedance connections

(page 18)

Since these settings can be made independently for channels

A/B and channels C/D, you can use more than one of the

above methods



When using low impedance connections

Depending on the impedance (4Ω or 8Ω) of the connected

speakers, set the [SPEAKERS] DIP switches as follows.

Setting

280W{140W}, 8Ω

280W{140W}, 4Ω

NOTE

If you make settings for low impedance connections, the

HPF will automatically be turned OFF.

The XMV features a switch function between 8Ω and 4Ω to

guarantee the output in case it is connected to a speaker with

an impedance of 8Ω or higher.

If you connect a speaker with an impedance of 8Ω or higher,

set the [SPEAKERS] DIP switches to 8Ω. If you connect a

speaker with an impedance of 4Ω or higher, but lower than

8Ω, set the [SPEAKERS] DIP switches to 4Ω.

Total impedance(x)

4Ω

8Ω

XMV4280/XMV4140/XMV4280-D/XMV4140-D Owner's Manual

Connections and Setting Up

10W

Switches 1–4

(channels C, D)

Switches 5–8

(channels A, B)

Setting

4Ω

8Ω