Yamaha XMV8280-D Benutzerhandbuch - Seite 18

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Yamaha XMV8280-D herunter. Yamaha XMV8280-D 42 Seiten. Ferrite cores
Auch für Yamaha XMV8280-D: Benutzerhandbuch (42 seiten), Benutzerhandbuch (42 seiten), Benutzerhandbuch (39 seiten), Gebrauchsanweisung (2 seiten)

Yamaha XMV8280-D Benutzerhandbuch
Connections and Setting Up
When using low impedance connections with
Double Power mode
If you use Double Power mode, input/output will be dis-
abled for channels B, D, F and H.
Depending on the impedance (4Ω or 8Ω) of the connected
speakers, set the [SPEAKERS] DIP switches as follows.
Setting
560W{280W}, 8Ω
560W{280W}, 4Ω
NOTE
If you make settings for low impedance connections, the
HPF will automatically be turned OFF.
When using high impedance connections
Depending on the specifications (70V or 100V) of the
system in which this unit is being installed, set the
[SPEAKERS] DIP switches as follows.
Setting
70V
100V
NOTE
If you make settings for high impedance connections,
the HPF will automatically be set to 80 Hz.

Connecting Speaker Cables

The [SPEAKERS] output connectors (page 15) on the rear
panel are barrier strip type connectors. We will explain con-
nections using a spade lug and connections using a bare con-
ductor.
CAUTION
Make sure that the power is turned off. If the power is
on, you risk electrical shock.
If using a spade lug
From below, insert the spade lug all the way, and tighten
the screw.
< 0.31"
=
( < 7.8mm)
=
> 0.15"
=
( > 3.7mm)
=
18
XMV8280/XMV8140/XMV8280-D/XMV8140-D Owner's Manual
Switches 1–4
Switches 5–8
* Actual size
Switches 1–4
Switches 5–8

Connecting the Power Cord

Connect the included power cord to the [AC IN] connector
(page 15) on the rear panel. First connect the AC power cord
to the connector on this unit, then plug it into an appropriate
AC power outlet.
If using a bare conductor
Wrap the conductor around the barrier strip terminal as
shown below, and tighten the screw. Be sure that the bare
wire does not touch the chassis.
Speaker cable
NOTE
• If the [SPEAKERS] DIP switches (page 15) are in Dou-
ble Power mode (switch 4 or 8 is in the lowered posi-
tion), audio will not be output from the corresponding
channel (channel B, D, F or H).
• Ensure that tension is not applied to the speaker cable.
• Connect the cables so that the amplifier's "+" and "-"
symbols match those of the speaker. If they are
reversed, the polarity will be reversed.
TIPS
Since a large amount of current can flow in a speaker
cable, a magnetic field will be generated. If sensitive cir-
cuits such as a microphone input cable or a microphone
amp are located near a speaker cable, electromagnetic
induction may produce noise in the input cable or circuit.
Input cables and devices that contain sensitive circuits
should be kept at a distance from speaker cables; we
also recommend that you fasten the cables in place.
CAUTION
You must turn off the power before connecting the
power cord.
Wire should
not touch
the chassis.