Clark Synthesis TACTILE SOUND AQ339 Aquasonic Installationshandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Installationshandbuch für Redner Clark Synthesis TACTILE SOUND AQ339 Aquasonic herunter. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 12 Seiten. Underwater speaker
Auch für Clark Synthesis TACTILE SOUND AQ339 Aquasonic: Ergänzendes Handbuch (4 seiten), Spezifikationen (1 seiten), Teileliste (1 seiten), Benutzerhandbuch (1 seiten), Referenzblatt (1 seiten), Installationshandbuch (3 seiten), Spezifikation (1 seiten), Installationshandbuch (20 seiten)

DROP-IN INSTALLATION

Purchase a length of rope (1/8" to 1/4" outside diameter) that will allow you to place the speaker in

the area of the pool where you would like sound (see General Information section at the beginning of

this manual for precautions when using this type of application). Carefully remove the speaker from

its box. Locate the open hole on the speaker's rubber ring (next to the interlaced speaker wire). Thread

the rope through the hole. Tie a knot that will not come undone or slip through the hole.

Connect the speaker to your audio system with the attached speaker wire. Carry the speaker to the

pool using the rope (NEVER CARRY THE SPEAKER BY THE SPEAKER WIRE! THIS WILL

DAMAGE THE SPEAKER!). Gently lower the speaker into the pool, insuring the speaker and

wire are not scratching along the wall of the pool (NEVER THROW THE SPEAKER INTO THE

WATER. THIS WILL DAMAGE THE SPEAKER AND MAY CAUSE PERSONAL INJURY).

When the speaker is under the water at the desired depth, insure the sound lens is facing away from

the wall and allow the speaker to rest against the wall. Tie the rope to a sturdy object (noting the

precautions listed in the front of this manual).

Underwater Speaker

When you are ready to remove the speaker from the water,

slowly raise the speaker to the surface of the water using

the rope (insure the speaker does not rub against the wall of

the pool). Use caution when the speaker reaches the water's

surface because the surface tension of the water increases

the drag on the speaker and could cause the rubber ring to

pull free from the speaker. Roll up the speaker wire and

rope. Use the rope to carry the speaker to its storage location

(NEVER CARRY THE SPEAKER BY THE SPEAKER

WIRE! THIS WILL DAMAGE THE SPEAKER!).