Clark Synthesis TACTILE SOUND AQ339 Aquasonic Installationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Installationshandbuch für Verstärken Clark Synthesis TACTILE SOUND AQ339 Aquasonic herunter. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 20 Seiten. Underwater speaker
Auch für Clark Synthesis TACTILE SOUND AQ339 Aquasonic: Ergänzendes Handbuch (4 seiten), Spezifikationen (1 seiten), Teileliste (1 seiten), Benutzerhandbuch (1 seiten), Referenzblatt (1 seiten), Installationshandbuch (12 seiten), Installationshandbuch (3 seiten), Spezifikation (1 seiten)

DROP-IN INSTALLATION

Find a length of rope (1/4" (6mm) outside diameter) that will allow you to place the speaker in the

area of the pool where you would like sound (see General Information section at the beginning of this

manual for precautions when using this type of application). Carefully remove the speaker from its

box. Locate the open hole on the speaker's rubber ring (next to the interlaced speaker wire). Thread

the rope through the hole. Tie a knot that will not come undone or slip through the hole.

Connect the speaker to your audio system with the attached speaker wire. Carry the speaker to the

pool using the rope (NEVER CARRY THE SPEAKER BY THE SPEAKER WIRE! THIS WILL DAMAGE THE

SPEAKER!). Gently lower the speaker into the pool, insuring the speaker and wire are not scratching

along the wall of the pool (NEVER THROW THE SPEAKER INTO THE WATER. THIS WILL DAMAGE

THE SPEAKER AND MAY CAUSE PERSONAL INJURY). When the speaker is under the water at the

desired depth, insure the sound lens is facing away from the wall and allow the speaker to rest against

the wall. Tie the rope to a sturdy object (noting the precautions listed in the front of this manual).

Diluvio

Underwater Speaker

™

When you are ready to remove the speaker from the water,

slowly raise the speaker to the surface of the water using

the rope (insure the speaker does not rub against the wall of

the pool). Use caution when the speaker reaches the water's

surface because the surface tension of the water increases

the drag on the speaker and could cause the rubber ring

to pull free from the speaker. Roll up the speaker wire

and rope. Use the rope to carry the speaker to its storage

location (NEVER CARRY THE SPEAKER BY THE SPEAKER

WIRE! THIS WILL DAMAGE THE SPEAKER!).