Directed 1-button series Installationshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Installationshandbuch für Fernstart Directed 1-button series herunter. Directed 1-button series 20 Seiten. Keyless entry remote start 4113, 1-button series

Seite drucken

Remote start shutdown diagnostics

If the remote start activates but fails to stay running, the remote start module has the ability to inform you of

what may have caused the remote start failure. Before performing shutdown diagnostics it is important that

you let the remote start shut off on its own i.e. let it attempt to start 3 times then shut down, if this is not done

the unit will report the shutdown you used to shut off the remote start.

Note: Shutdown diagnostics does not report if the vehicles factory immobilizer is causing the problem.

To perform shutdown diagnostics:

1. With the ignition Off, press and hold the Valet button

2. Turn the ignition On and then back Off while holding the Valet button.

3. Release the Valet button.

4. Press and release the Valet button. The status LED flashes to report the last shutdown for one minute or

until the ignition is turned on, as shown in the following table:

Status LED Flashes

1 flash

2 flashes

3 flashes

4 flashes

5 flashes

6 flashes

7 flashes

8 flashes

Remote programming

1. Turn key to the ON position

2. Within 5 seconds, press and release Valet button one time.

3. Within 5 seconds, press and hold the Valet button. The LED will flash one time and the horn honks to

confirm entry into remote programming.

4. Press the button on the remote control.

5. The horn honks to confirm the remote has been programmed.

6. Release the Valet button, and turn the key to the Off position.

7. The horn sounds one long honk to confirm that remote programming has been exited.

The programming routine exits if any of the following occurs:

•

The ignition is turned off

•

There is no activity for 30 seconds

•

The Valet button is pressed too many times

Shutdown Mode

Runtime expired

Over-rev shutdown

Low or no RPM

Transmitter shutdown (or optional push button)

(-) Hood shutdown (H3/4 GRAY)

(+) Shutdown (H3/3 BROWN)

Neutral safety shutdown (H3/1BLACK/WHITE)

Wait-to-start timed out