Clarke 3120116 Betriebs- und Wartungsanleitung - Seite 11
Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Elektrowerkzeug Clarke 3120116 herunter. Clarke 3120116 17 Seiten. Ratchet wrench
Seite drucken
MAINTENANCE
WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE
COMPRESSED AIR SUPPLY BEFORE STARTING ANY CLEANING OR
MAINTENANCE PROCEDURES.
DAILY
1. Before use, drain water from the compressed air supply.
2. If no line lubricator or mini oiler is used, ensure that oil is applied to the tool
on a daily basis through the air inlet connection. Run a few drops of oil
through the tool before use. It may be entered into the tool air inlet,
(ensuring the strainer is clear), or into the hose at the nearest connection to
the air supply.
3. This procedure should be repeated after every two to three hours of use or
at the start of the working day.
4. Keep the body of the tool clean and free from debris.
WEEKLY
1. Check the air inlet screen filter for
blockage and clean if necessary.
CLEANING
1. Grit or gum deposits in the tool
may reduce efficiency.
2. After extensive use, remove the
inlet screen filter and flush out the
mechanism with gum solvent oil or
an equal mixture of CLARKE air-
line oil and paraffin. Allow to dry before use.
3. If the tool still runs erratically or becomes inefficient and the air supply is of
good quality, it may be necessary to dismantle the air motor and replace
worn or damaged parts. You may prefer to take the tool to your CLARKE
dealer if internal maintenance is required.
PERFORMANCE
Please note that outside factors may effect the operation and efficiency of
the tool, such as reduced compressor output, excessive drain on the airline,
moisture or restrictions in the air-line, or the use of connectors of improper size
or poor condition which will reduce air supply.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11