Directed AS-3472TW Benutzerhandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Fernstart Directed AS-3472TW herunter. Directed AS-3472TW 20 Seiten.

Seite drucken

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors locked

while you stop, for example, at a convenience store or for a short delivery.

This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the

Ignition Switch) while the engine is running.

Activating Idle mode (Automatic transmission):

With the engine running, make sure to release the brake pedal and press the

button on the transmitter until the parking lights come ON.

Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Idle mode.

Remove the ignition key from the ignition switch.

The engine will continue running.

Exit the vehicle. All doors, the hood and trunk should be closed

Press the

available). The engine will continue running.

When re-entering the vehicle, the user must reinsert the key into the ignition and

turn it to the ON position (not Crank) without pressing on the brake.

Once the key is in the ON position, press on the brake pedal to put the

transmission in gear. Pressing the brake pedal at this step will cancel the remote

starter takeover.

Drive off.

If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as

that used for Ready Mode (page-9); at the last step, press the

the system and leave the engine running.

Valet Modes

When the vehicle is in Valet Mode, the remote starter and alarm functionalities are disabled. If the

vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from

being remote-started accidentally.

Any of the following features will put the remote car starter into Valet Mode:

Ignition Valet: This feature allows you to set Valet Mode using the ignition key.

Remote valet: This feature allows you to set Valet Mode using the transmitter.

Using the KEY (Ignition Valet Mode):

Insert the ignition key into the ignition switch. Within 10 sec., turn the key to the

IGNITION/RUN and OFF positions until parking lights flash 3 times.

Turn the ignition OFF.

The LED on the antenna will stay ON indicating that the vehicle has successfully entered

Valet mode.

The

icon will appear on the LCD remote if the

Using the TRANSMITTER (Remote Valet Mode):

Press the

The LED on the antenna will stay ON indicating that the vehicle has successfully entered

Valet mode.

P.12

button to lock the doors, to arm the starter kill and to arm the alarm (if

To put the system into Valet Mode

and

buttons simultaneously until the

button to lock the doors, arm

button is pressed.

icon appears on the LCD display.

User Guide