Clarke 3400771 Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Clarke 3400771 herunter. Clarke 3400771 17 Seiten. Plastic stapler/welder kit

Seite drucken

10. Give the device a very slight twist to help the staple become completely

embedded under plastic to prevent any chance of it pulling out.

11. Use a straight staple when

repairing along the edge of the

workpiece.

12. Cut off the exposed part of the

staple or rock it back and forth

with your hands until it breaks off.

• A pair of end cutting pliers may

be very useful for this. If using

these, wear safety glasses to

protect from flying staple ends.

13. Use the welding tip to heat the

welds and any protruding plastic

next to it wrapping and levelling

with melted plastic to strengthen the connection.

NOTE: the underside of the repair may become hot while working.

14. Once the repair is completed, the

staple ends and rough plastic can

be cleaned off using a sanding

disc or similar tool but taking care

not to remove any significant

material from the repaired plastic

component.

NOTE: If operated continuously on its maximum heat setting the thermal

cut-out may be triggered. The device will shut down with the

alarm sounding an intermittent tone until the device cools down

enough to reset the cutout.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]