Clarke 6480232 Handbuch für Betrieb und Wartung - Seite 4
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Elektrowerkzeug Clarke 6480232 herunter. Clarke 6480232 8 Seiten. Drill bit sharpener
Seite drucken
OPERATIONS
CONNECTING TO A DRILL
1. Make sure the jaws on the drill
chuck are fully closed.
• The drill used must have a 43
mm collar and a 13mm (
inch) chuck.
2. Push the drill bit sharpener onto
the drill as shown.
3. If required loosen the wing nuts to
slide the outer tube over the
chuck.
4. When in place, the outer tube
should grip the collar of the drill
and not the chuck and onto the
collar of the drill.
• The drill is connected to the drill
bit sharpener by friction only
PROPERLY SHARPENED BITS
Your bit is properly sharpened when it
has the following characteristics.
• A sharp point in the center of the bit.
• Two sharp and equal cutting edges
• Two trailing edges that are slightly lower than the cutting edges.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
½
4