Clarke CPSB200B Handbuch für Betrieb und Wartung - Seite 5
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Elektrowerkzeug Clarke CPSB200B herunter. Clarke CPSB200B 17 Seiten. Pressurised sandblaster
Seite drucken
ASSEMBLY
FIT THE PRESSURE GAUGE TO THE TANK
1. Screw the pressure gauge onto
the sandblaster as shown in Fig 1.
FIT THE HANDLE BARS TO THE TANK
1. Lay the tank on a flat level surface
such as a workbench, with the
handlebar mounting brackets
facing up, as shown in Fig 2.
2. Align the holes in the left
handlebar with the handlebar
mounting brackets on the left side
of the tank.
3. Fit a washer to each of the
handlebar mounting screws. Insert
a screw through each hole in the handlebar and mounting brackets.
4. Fit a nut onto each of the screws and firmly tighten with a wrench.
5. Repeat steps 2-4 for the right handlebar.
ASSEMBLE THE AXLE
1. Slide the axle through the holes at
the bottom of the handlebars, see
Fig 3.
2. Slide a washer onto each end of
the axle.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Fig 3
5
Fig 1
Fig 2