Directed Directechs DB3 Installationshandbuch - Seite 5

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in

pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.

T-Harness

compatible

Key2GO may be required if the interface does not program using the traditional method. Refer to "Module programming"

for more information.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic

connector.

The Power Liftgate and Sliding Door controls are ONLY available when the engine is OFF (where applicable).

All connectors are displayed from the wire side (unless specified otherwise).

Refer to the "Vehicle connections" following the installation diagram.

General notes: This section highlights important information for this specific firmware.

The Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

The steering lock connection is ONLY required if the connector is present in the vehicle.

[2]

When using an external relay, use a 1N4002 diode or larger. Directed Part No. 8616 Minin Relays must be used for this

[3]

connection. Refer to the "8616 wire and color reference" on the installation diagram.

403.HONDA9 1.12 2014 Acura RLX (Smart Key)

Keys required for

programming

operation