Clarke RI150LI Handbuch für Betrieb und Wartung - Seite 8
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Elektrowerkzeug Clarke RI150LI herunter. Clarke RI150LI 13 Seiten. Rechargeable inflator
Seite drucken
PRESSURE DETECTION AND INFLATION
A short press on the power button will start
inflation. A second short press will stop inflation.
When the pressure reaches the pre-set pressure
value the pump will automatically stop. After
turning on, connect the hose to the object to be
measured. The real-time pressure (12) will show the
pressure value.
PRESSURE CALIBRATION
After turning on, if the displayed pressure value is
not 0, press button (+) and (-) simultaneously for 2
seconds to enter the calibration mode. The display
will flash quickly, meaning the reset is complete.
Note: The device has been calibrated at the factory but a Reset/calibration
can improve accuracy due to variations in air pressure due to altitude.
DO NOT attempt to re-calibrate while connected to inflatable objects.
COMMON INFLATION PRESSURES
Car
Motorcycle
Bicycle
Ball
• When inflating tyres with normal "Schrader" valves, no adaptors need to
be fitted to the hose.
• Presta valves require the adaptor to be screwed onto the valve before
attaching the hose.
Avoid inflating the objects above the recommended inflation pressure. This
could lead to damage and /or injuries.
Low pressure products such as balloons/swimming rings/balls are outside the
minimum pressure range of the product as the air pressure is very low and the
pressure value cannot be pre-set. Use the inflator with caution.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PSI
35 - 50
26 - 40
35 - 100
3-14
8
KPA
240 - 350
180 - 275
240 - 690
20-100
BAR
2.4 - 3.5
1.8-2.75
2.4-6.9
0.2-1.0