Directed Directechs DB3 Installationshandbuch - Seite 4

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

compatible

Vehicle Takeover

Firmware notes

Remote Start Ready (RSR):

•RSR installations are not compatible with vehicles equipped with a manual transmission.

•RSR is a function that enables the interface module to remote start the vehicle completely on its own.

Consequently, there is no need for an aftermarket or an OEM remote starter in order to start the vehicle from a distance.

•SmartStart compatible: SmartStart is equipped with D2D, which means it can be connected to an interface module and used in

Remote Start Ready (RSR) mode without the use of a remote starter. See "Module programming" for more information.

T-Harness CHTHD2/THCHD2 notes:

•All T-Harness wires not listed in the diagram are not required for the installation.

•The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.

•The optional Plug & Play T-Harness is sold separately

All connectors are displayed from the wire side (unless specified otherwise).

Refer to the "Vehicle connections" following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin or if

not supported in data.

403.CHRYSLER 7.36 2013 Chrysler 200

CHTHD2/THCHD2

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation