Clarke STRONG-ARM CSA10BB Handbuch für Betrieb und Wartung - Seite 8
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Elektrowerkzeug Clarke STRONG-ARM CSA10BB herunter. Clarke STRONG-ARM CSA10BB 17 Seiten. 10 tonne hydraulic bench press
Seite drucken
OPERATION
1. Place the workpiece on the bed. It must be completely stable and
supported by packing or shims where required. 'Heel' blocks (arbor plates)
are supplied, which locate on the bed. Place the workpiece on a
combination of these to give it stability
CAUTION: DO NOT POINT LOAD THESE ACCESSORIES AS THEY ARE NOT
DESIGNED TO TAKE THE FULL FORCE OF THE RAM IN ONE SPOT. ENSURE
THEY ARE ADEQUATELY SUPPORTED.
NOTE: Any packing pieces or shims used MUST be capable of
withstanding the pressure that will be brought to bear, and MUST
be of sufficient size with sufficient surface area, so as to avoid the
possibility of slipping or springing out. Mating surfaces MUST be
horizontal so that the force being exerted will NOT be at an angle.
2. Close the release valve by turning
it clockwise until tightly closed.
3. Pump the handle to bring the ram
very lightly into contact with the
workpiece.
4. Manoeuvre the workpiece so that
the desired point of contact is
directly beneath the centre of the
ram.
5. When satisfied that the workpiece
is correctly aligned and is completely stable in that position, slowly pump
the handle so that the ram begins to exert pressure on the workpiece.
Continue to pump the handle whilst standing to the side. Do NOT stand
directly in front of the work and constantly monitor the process, ensuring
the ram and work remain completely in line and there is no risk of slipping.
6. When the process is complete, turn the release valve anticlockwise in small
increments to release ram pressure and allow removal of the workpiece.
WARNING: NEVER USE EXTENSIONS TO THE RAM PUMPING HANDLE.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8