Clarke STRONG-ARM CSA12F Handbuch für Betrieb und Wartung - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Elektrowerkzeug Clarke STRONG-ARM CSA12F herunter. Clarke STRONG-ARM CSA12F 17 Seiten. 12 tonne hydraulic press
Auch für Clarke STRONG-ARM CSA12F: Handbuch für Betrieb und Wartung (17 seiten)
Seite drucken
POSITIONING THE BED
IMPORTANT: Due to the weight of the bed, we recommend that you get
assistance from another person when adjusting the bed height.
1. Position the bed at the desired height, so that it will be as close as possible
to the ram when the workpiece is mounted on it.
2. Raise one side of the bed and insert a supporting pin into the next locating
hole.
3. Repeat at the other end to level the bed.
4. Repeat until the bed is at the desired height, with the supporting pins fully
'home'.
CAUTION: THE BED HEIGHT SHOULD ONLY BE RAISED OR LOWERED ONE
HOLE AT A TIME, WORKING ALTERNATELY FROM ONE SIDE AND THEN THE
OTHER, FAILURE TO WORK IN THIS WAY MAY CAUSE THE BED TO FALL
AND CAUSE INJURY TO THE OPERATOR.
POSITIONING THE RAM
The ram can positioned as required
by sliding it along the cross-beam.
Lock it in position with the socket
head adjusting bolt on each side.
• Always position the ram directly
above the workpiece.
FITTING THE MANDRELS OR PRESSURE CAP
Four mandrels are provided, any of
which may be connected to the end
of the ram using the adaptor
supplied.
Alternatively, the basic ram pressure
cap can be fitted as shown. Secure
the pressure cap by tightening the
grub screw with a suitable hex key.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7