Zanussi ZBB28650SA Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kühlschrank Zanussi ZBB28650SA herunter. Zanussi ZBB28650SA 16 Seiten. Fridge-freezer zbb28650sa

Seite drucken

Environment Protection

This appliance does not contain gasses which could

damage the ozone layer, in either its refrigerant cir-

cuit or insulation materials. The appliance shall not be

discarded together with the urban refuse and rubbish. The

Control panel

Pilot Light

Temperature Regulator

Action Freeze light

Action Freeze switch

Switching on

Insert the plug into the wall socket.

Turn the Temperature Regulator clockwise to a medium

setting.

The Pilot Light will light up.

Switching off

To turn off the appliance, turn the Temperature Regulator

to the "O" position.

The Pilot Light will switch off.

Temperature regulation

The temperature is automatically regulated.

To operate the appliance, proceed as follows:

• turn the Temperature Regulator toward lower settings

to obtain the minimum coldness.

• turn the Temperature Regulator toward higher settings

to obtain the maximum coldness.

First use

Cleaning the interior

Before using the appliance for the first time, wash the inte-

rior and all internal accessories with lukewarm water and

some neutral soap so as to remove the typical smell of a

brand-new product, then dry thoroughly.

insulation foam contains flammable gases: the appliance

shall be disposed according to the applicable regulations

to obtain from your local authorities. Avoid damaging the

cooling unit, especially at the rear near the heat exchang-

er. The materials used on this appliance marked by the

symbol

are recyclable.

A medium setting is generally the most suitable.

However, the exact setting should be chosen keeping in

mind that the temperature inside the appliance depends

on:

• room temperature

• how often the door is opened

• the quantity of food stored

• the location of the appliance.

Action Freeze function

Press the Action Freeze switch to activate the Action

Freeze function.

The Action Freeze light will light up.

Important! This function stops automatically after 52

hours.

Press the Action Freeze switch to deactivate the function at

any time. The Action Freeze light will switch off.

Important! Do not use detergents or abrasive powders, as

these will damage the finish.