Zanussi ZC246R3 Gebrauchsanweisung - Seite 13

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kühlschrank Zanussi ZC246R3 herunter. Zanussi ZC246R3 14 Seiten. Fridge zc246r3

Seite drucken
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the
appliance is positioned below an overhanging wall
unit, the minimum distance between the top of the
cabinet and the wall unit must be at least 100 mm
(A). Ideally, however, the appliance should not be
positioned below overhanging wall units (B).
Accurate levelling is ensured by one or more
adjustable feet at the base of the cabinet.
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
This appliance complies with the following
E.E.C. Directives:
of 2/6/87 relative to radio interference
suppression.
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
The plastic bag containing all relevant
documentation also contains two rear wall spacers
to be fitted into special slots on the back of the
appliance. Fit the spacers into the slots, taking care
to ensure that the arrow (A) is positioned as shown
in the figure. Next, turn them through 45° (arrow in
vertical position) until they lock into place.
16
A
B
NP00
It must be possible to disconnect the
appliance from the mains power supply; the
plug must therefore be easily accessible after
installation
A
45°
PR60
The walls of the refrigerator are equipped with a
series of runners so that the shelves can be
positioned as desired.
To permit storage of food packages of various sizes,
the door shelves can be placed at different heights.
To make these adjustments proceed as follows:
Gradually pull the shelf in the direction of the arrows
until it comes free, then reposition as required.
Useful hints:
wrap in polythene bags and place
on the glass shelf above the vegetable drawer.
these should be
covered and may be placed on any shelf.
these should be thoroughly
cleaned and placed in the special drawer(s)
provided.
these should be placed in
special airtight containers or wrapped in aluminium
foil or polythene bags to exclude as much air as
possible.
these should have a cap and should
be stored in the bottle rack on the door.
D040
PR260
13