Zanussi ZR 170 UN Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kühlschrank Zanussi ZR 170 UN herunter. Zanussi ZR 170 UN 12 Seiten.

Seite drucken

Fitting a decorative door panel

Important: The components needed to ﬁt the

decorative panel have been pre-ﬁtted on the

appliance.

The brackets are secured to the panel by means of

the 7 Ø 3.5x13 screws supplied.

Before starting to ﬁt the panel, remove the large

top bracket by unscrewing the screws and

adjusting pins pre-ﬁtted on the appliance door.

The small bottom bracket need not be removed.

Place the appliance in the position where it is to be

built in (Fig. 5).

The appliance is ﬁtted with adjustable feet; screw the

front and rear feet in or out to adjust the height of the

appliance to that of the recess.

Keeping the appliance central in the recess, slide it in

until its back touches the wall.

With a tape measure (or similar instrument), measure

distance (A) between the top edge of the door and the

top edge of the decorative panel, placing it next to the

recess.

Lay the panel face down (Fig. 6). Position the top

bracket on the panel, making sure that there is an

equal distance between it and the sides and that its

distance from the top edge is equal to distance (A)

less 1 cm.

Secure the bracket with the screws supplied.

Take care not to damage the front face of the panel

whilst working.

Insert the adjusting pins (B-Fig. 7) into their locations

in the door and screw them in.

Hook the decorative panel onto the top part of the

door, inserting the pins (B) (on the door) into the

elongated holes (1) (in the top bracket ﬁtted to the

panel) (Fig. 8).

Insert the securing screws (C) through elongated

holes (2) and ﬁx the panel without tightening the

screws (Fig. 8).

D467

D468

D532

D533

Fig. 5

Fig. 6

-1cm

Fig. 7

Fig. 8