Zanussi ZRB38313WA Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kühlschrank Zanussi ZRB38313WA herunter. Zanussi ZRB38313WA 16 Seiten.
Seite drucken
The lowest shelf, dividing the cooler
compartment from the 0°C compartment can be
removed only for cleaning. To remove it pull out
the shelf straight. The cover plates above the
drawers in the compartment can be taken out
for cleaning.
To ensure the best performance of
the 0°C compartment the lowest
shelf and cover plates must be put
back in their original position after
cleaning.
Defrosting
Your appliance is frost free. This means that
there is no build up of frost when it is in
operation, neither on the internal walls nor on
the foods.
The absence of frost is due to the continuous
circulation of cold air inside the compartment,
driven by an automatically controlled fan.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The lamp does not work.
The lamp does not work.
The compressor operates contin-
ually.
10
Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. Disconnect the appliance from electricity
2. Remove all food.
3. Leave the door/doors open to prevent
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrectly.
Many food products were put
in at the same time.
supply.
unpleasant smells.
WARNING!
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside from
spoiling in case of a power failure.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact
a qualified electrician.
Check if the appliance stands sta-
ble.
Close and open the door.
Contact the nearest Authorised
Service Centre.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Solution
www.zanussi.com