Zanussi ZRD 18 JB Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kühlschrank Zanussi ZRD 18 JB herunter. Zanussi ZRD 18 JB 18 Seiten. Refrigerator- freezer combination

Seite drucken

Remaining small ice and frost stains on back plate of the

refrigerator after defrosting period is not abnormal.

The freezer can not be equipped with automatic defrost-

ing set since the deep-frozen and frozen foods do not

endure melting temperature.

When small frost and ice occurs scrape off and remove

frost and ice coating with the supplied plastic scraper.

The tray in figure is not a piece of accessories to the appli-

ance!

When ice coating is so thick that it cannot be removed

with the plastic scraper, the cooling plate has to be

defrosted. Frequency of defrosting depends on usage

(generally 2-3 times a year).

Take the frozen foods out of the appliance, and put them

into a basket lined with paper or cloth. Store them in a

possibly cool place or replace them into another refriger-

ator.

Pull out the mains plug from the mains socket, so both

parts of the appliance are out of operation.

Open the doors of both parts of the appliance and clean

the refrigerator according to 'Regular cleaning'. Maintain

and clean the freezer as following:

Sweep the melting water with a cloth or sponge off the

cooling plate. The melting water swept down gathers in

the bottom of the appliance and can be removed with a

hygroscopic cloth or a sponge.

Wipe the surfaces after defrosting.

Put the mains plug into the mains socket and put foods

taken out back to their places.

It is recommended to operate the appliance at the highest

position of the thermostatic control for some hours so that

it can reach the sufficient storing temperature as soon as

possible.

Regular cleaning

It is recommended to wash the inside of the refrigerator

in 3-4 weeks time using lukewarm water then wipe it (it is

practical to clean the inside of the freezer and defrost it at

a time).

Household cleaner or soap must not be used.

After breaking the circuit wash the appliance with luke-

warm water then wipe it. Clean the door gasket with

clean water. After cleaning apply voltage to the appli-

ance.

It is recommended to remove the dust and dirt collected

on the back of the refrigerator and the condenser and to

clean the evaporative tray on top of the compressor once

or twice a year.

When the refrigerator is not in use

In case the appliance will not be used for a long time fol-

low these steps:

Break the circuit of the appliance.

Remove foods from the refrigerator.

Defrost and clean it as written before.

Leave the door open to avoid a build up of air inside.

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:

Break the circuit of the appliance.

Unscrew the screw holding the cover (1), press the rear

hook (2) and at the same time slide the cover in the direc-

tion indicated by arrow (3). So the bulb can be replaced.

(Bulb type: 230-240 V, 15 W, E 14 thread)

After changing the bulb replace the cover, snap it in

place, screw back the screw and apply voltage to the

appliance.