Zanussi ZSS 7/5 W Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kühlschrank Zanussi ZSS 7/5 W herunter. Zanussi ZSS 7/5 W 20 Seiten.

Seite drucken

OPERATION

Before use

Remove all securing tapes. Wash inside the appliance

with lukewarm water and bicarbonate of soda

(5 ml to 0.5 litre of water). Do not use soap or deter-

gent as the smell may linger. Dry thoroughly.

Setting the temperature

The temperature inside the refrigerator is regulated by

a thermostat with 6 temperature positions and one

«OFF» (O) position.

Position 1 = minimum cold

Position 6 = maximum cold

Turn the thermostat dial to the required position.

An intermediate position is usually the most suitable,

although the temperature will be affected by:

Room temperature

How often the door is opened

How much food is stored

Position of the appliance

In determining the correct temperature control setting

all these factors have to be considered and some

experimentation may be necessary.

When altering the temperature setting, allow 24 hours

for the temperature to stablise before making further

changes.

Important

During prolonged periods of abnormally hot

weather, if the thermostat is set on too high

a number, the cooling system may operate

continuously and the fridge cooling plate

may not defrost. Turning the knob to a lower

number will cause the automatic defrosting

to resume.

Ambient Temperature Switch

The appliance is designed to operate in room temper-

atures of 16°C to 32°C, or down to 10°C if the ambi-

ent switch is switched on. The ambient switch should

be switched on when the room temperature drops

below 16°C (the incorporated lamp will illuminate). If

the room temperature drops below the above figures

the temperature in the freezer may rise above -18°C,

then safe storage of frozen food can no longer be

guaranteed. It is most likely that the ambient switch

will need to be depressed throughout the winter to

allow for low overnight temperatures. No damage can

be caused by leaving the switch in this position for a

period of time but energy will be wasted.

A. Thermostat dial

B. Ambient switch

D325