Zanussi ZOF35501 Benutzerhandbuch - Seite 15
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Backofen Zanussi ZOF35501 herunter. Zanussi ZOF35501 24 Seiten. Oven
Auch für Zanussi ZOF35501: Benutzerhandbuch (24 seiten), Benutzerhandbuch (24 seiten)
Seite drucken
4. Set the maximum oven temperature and let
the oven operate for 1 hour.
5. Clean the oven cavity with a soft and damp
sponge.
Caution! Do not attempt to clean catalytic
surfaces with oven sprays, abrasive
cleaners, soap or other cleaning agents. This
may damage the catalytic surface.
Discolouration of the catalytic surface has
no effect on catalytic properties.
Shelf Support Rails
You can remove the shelf support rails to clean
the side walls.
Removing the shelf support rails
1
Pull the front of
the shelf support rail
away from the side
wall.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the
door from the appliance. The door is
heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two door
hinges fully.
www.zanussi.com
2
Pull the rear shelf
support rail away
from the side wall and
remove it.
A
3. Close the oven door until the first position
(angle approx. 45°).
45°
4. Hold of the oven door with one hand on
each side and pull it away from the oven at
an upwards angle.
Put the oven door with the outer side
down on a soft and level surface to pre-
vent scratches.
5. Now you can remove the inner glass pan-
els and clean them.
To install the door follow the procedure in
reverse.
The oven door has 2, 3 or 4 panels of
glass (depends on the model)
Removing and cleaning the door glasses
1. Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
B
2. Pull the door trim to the front to remove it.
A
15