Zanussi ZOS78964XU Benutzerhandbuch - Seite 44

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Backofen Zanussi ZOS78964XU herunter. Zanussi ZOS78964XU 49 Seiten.

Seite drucken
One of the hinge-arms (normally the
right one) is free to move. Make sure,
that both hinge-arms are in the same
position (approximately 70° angle).
WARNING! Make sure that the
glasses are inserted in the correct
position otherwise the surface of the
door may overheat.

REPLACING THE LAMP

WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The top lamp
1. Turn the lamp glass cover to remove it.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate or operate
the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
44
2. Remove the metal ring and clean the glass
cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Attach the metal ring to the glass cover.
5. Install the glass cover.
The side lamp
1. Remove the left shelf support to get access to
the lamp.
2. Use a Torx 20 screwdriver to remove the cover.
3. Remove and clean the metal frame and the
seal.
4. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
5. Install the metal frame and the seal. Tighten the
screws.
6. Install the left shelf support.
Possible cause
The oven is not connected to
an electrical supply or it is con-
nected incorrectly.
The oven is turned off.
The clock is not set.
The necessary settings are not
set.
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connection
diagram if available).
Turn on the oven.
Set the clock.
Make sure that the settings are
correct.