Zanussi FL 1090 Benutzerhandbuch - Seite 13
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Waschmaschine Zanussi FL 1090 herunter. Zanussi FL 1090 26 Seiten. Front-loading washing machine
Seite drucken
9 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of
button 11, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided:
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
10 RESET (ANULAR) button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear and the audible warning signals relevant to
the end of the previous cycle will be given.
You can also press the RESET (ANULAR) button to
exclude one or several phases of the programme
which is running, as indicated below:
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the RESET (ANULAR) button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the phase(s) will go out).
Example:
(INICIO/PAUSA)
In this case, the spin
(at the speed provided
for the selected type of
fabric) will be
performed.
37
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress RESET (ANULAR) once or repeatedly to
cancel the previously performed programme (three
blinking dashes will appear on the display);
- select the type of fabric by means of button
TEJIDOS;
- select the special programme:
• RINSES
Depress RESET (ANULAR) once, the pilot light
WASH
goes out.
• SPIN
Depress RESET (ANULAR) twice, the pilot lights
WASH
and RINSES
• DRAIN
Depress RESET (ANULAR) three times, the
pilot lights WASH
, RINSES
go out.
Example:
• If the machine is switched off:
- depress ON/OFF button to switch it on;
- select the type of fabric by means of button
TEJIDOS:
- select the special programme as previously
described.
go out.
and SPIN
In this case the
machine will perform
the rinses and spin.