Zanussi DTI 6759 E Gebrauchsanweisung - Seite 16

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Geschirrspüler Zanussi DTI 6759 E herunter. Zanussi DTI 6759 E 27 Seiten. Dishwasher dti 6759 e

Seite drucken

Operating sequence

1. Check the filters

Ensure they are clean and properly

positioned (see cleaning instructions).

2. Check that there is rinse aid

and salt

3. Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the

saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the

plates, saucers, glasses and cups etc. in it.

Slide the basket back into the machine.

4. Ensure that the spray arms can

rotate freely.

5. Measure out detergent

Add the required amount of detergent into

the dispenser according to the "Washing

programmes" chart and close the lid.

6. Set the programme

The selection of a programme occurs with

the door partially opened.

Depress the On/Off button. The number "1"

corresponding to the first selectable

programme appears in the display.

Press the programme selector button until

the number corresponding to the required

programme appears in the display. The pilot

light continues to flash until the programme

is started.

The following options may also be selected:

"Economy drying" by pressing the relevant

button.

"Delay start" by pressing the relevant button

until the required number of hours delay is

setted.

7. Start the programme

Close the dishwasher door. An audible signal

of about 1 second advises you that the

programme has started. If a delay start has

been selected, the dishwasher starts the

countdown and the number of hours to go

before the programme starts appears in the

display.

A flashing dot indicates that the function is

active. Once the set delay has elapsed, the

programme starts automatically.

8. At the end of the washing

programme

The dishwasher will automatically stop and

an intermittent audible signal of about 5

seconds informs you that the programme

has finished.

A flashing horizontal line appears in the

display. This signal remains until the

programme selector button is pressed.

Wait until the end of the signal before

opening the door.

9. Switch off the dishwasher

Open the door.

Depress the On/Off button to switch the

dishwasher off.

10. Cancel the wash programme

To change a wash programme in progress

depress the "Cancel/Change programme"

button until the short "instruction accepted"

signal (about 2 seconds) is heard. The

number "1" indicating the first selectable

programme appears in the display and the

programme selector light flashes: the

previous setting has been cancelled and a

new programme can now be selected.

When the wash programme has

finished, it is recommended that the

dishwasher is unplugged and the water

tap turned off.

In general it is not advisable to open the

door while the machine is working;if the

door is opened however, a safety device

ensures that the machine stops.

Caution

Do not open the door during the hot

phase: this may cause hot water

escape.

Care must be taken if the door is

opened during the hot phase or

immediately after a programme has

finished, as steam may escape.

POS08/1GB