Zanussi ZDT36001FA Benutzerhandbuch - Seite 16
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Geschirrspüler Zanussi ZDT36001FA herunter. Zanussi ZDT36001FA 21 Seiten.
Seite drucken
Problem and alarm code
The appliance door is difficult
to close.
Rattling/knocking sounds from
inside the appliance.
The appliance trips the circuit-
beaker.
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
16
Possible cause and solution
•
The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
•
Parts of the tableware are protruding from the baskets.
•
The tableware is not properly arranged in the baskets. Refer to
basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneously all the ap-
pliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
•
Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
Possible cause and solution
•
Refer to "Daily use", "Hints and tips" and the basket load-
ing leaflet.
•
Use more intensive washing programmes.
•
Clean spray arm jets and filter. Refer to "Care and Clean-
ing".
•
Tableware was left for too long inside the closed appliance.
•
There is no rinse aid or the dosage of rinse aid is not suffi-
cient. Set the rinse aid dispenser to a higher level.
•
Plastic items may need to be towel dried.
•
For the best drying performance activate the option XtraDry
and set AirDry.
•
We recommend to use rinse aid always, even in combination
with multi-tablets.
•
The released quantity of rinse aid is too high. Adjust the rinse
aid level to a lower level.
•
The quantity of detergent is too high.
•
The released quantity of rinse aid is not sufficient. Adjust the
rinse aid level to a higher level.
•
The quality of the rinse aid can be the cause.