Zanussi ZEE6940 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kochfeld Zanussi ZEE6940 herunter. Zanussi ZEE6940 12 Seiten. Product manaul
Auch für Zanussi ZEE6940: Benutzerhandbuch (36 seiten), Benutzerhandbuch (16 seiten), Benutzerhandbuch (48 seiten), Benutzerhandbuch (40 seiten)

Seite drucken

• A qualified electrician must install the clamp-

ing connections correctly.

• Use a strain relief clamp on cable.

• Use the correct mains connection cable and

replace the damaged mains cable with the

proper cable type. Speak to your local Serv-

ice Centre.

The appliance must have the electrical installa-

tion which lets you disconnect the appliance

from the mains at all poles with a contact open-

ing width of minimum 3 mm. You must have

correct isolation devices: line protecting cut-

outs, fuses (screw type fuses removed from the

holder), ground leakage trips and contactors.

The manufacturer is not responsible for

any injury to persons and pets or damage

to property caused by failure to obey

these requirements.

Electrical connection

• Ground the appliance according to safety

precautions.

• Make sure that the rated voltage and type of

power on the rating plate agree with the volt-

age and the power of the local power supply.

• The appliance is fitted with a five pole termi-

nal box whose cables are predisposed for

230 V monophase function.

3 4 5

In case of different voltage, carry out the

connection as shown in connection sche-

matic table on the lower protection.

• Any electrical component must be installed

or replaced by the Service Force Centre

technician or qualified service personnel.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• The appliance must not be connected with

an extension cable, an adapter or a multiple

connection (risk of fire). Check that the

ground connection is in conformity with the

standard and regulations force.

• The power cable must be placed in such a

way that it does not touch any hot part.

• Connect the appliance to the mains with a

device that lets to disconnect the appliance

from the mains at all poles with a contact

opening width of minimum 3 mm, eg. auto-

matic line protecting cut-out, earth leakage

trips or fuse.

• None of a parts of the connection cable can

not get a temperature 90°C. The blue neutral

cable must be connected to the terminal

block label with "N". The brown (or black)

phase cable (fitted in the terminal block con-

tact marked with "L") must always be con-

nected to the live phase.

Connection cable

Use only connection cable of type H05V2V2-F

T90 or equivalent type. Make sure that the ca-

ble section is applicable to the voltage and the

working temperature. The yellow/green earth

wire must be approximately 2 cm longer than

the brown (or black) phase wire.

Building In

min. 600 mm

min. 55 mm

30 mm

10 mm

3 mm

min. 650 mm

560 mm

11 mm