Zanussi ZGF 692 C Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kochfeld Zanussi ZGF 692 C herunter. Zanussi ZGF 692 C 16 Seiten. Zanussi instruction booklet gas hob zgf 682, zgf 692
Auch für Zanussi ZGF 692 C: Gebrauchsanweisung (32 seiten)

Seite drucken

1. Instructions for the Installer

Operation

Hob burners

To light a burner:

turn the relevant control knob anticlockwise to the

maximum position, then push it down to ignite the

burner;

then, check the flame is regular and adjust it as

required.

If you cannot light the flame even after several attempts,

check the "cap" and "crown" (see Fig. 1 - letter A and

B) are in the correct position.

To put the flame out, turn the knob to the symbol .

When switching on the mains, after installation

or a power cut, it is quite normal for the spark

generator to be activated automatically.

To ensure maximum burner efficiency, you should only

use pots and pans with a flat bottom fitting the size of

the burner used (see table).

Burner

Ultra-rapid

(Triple-crown)

Medium (semi-rapid)

Small (Auxiliary)

If you use a saucepan which is smaller than

the recommended size, the flame will spread

beyond the bottom of the vessel, causing the

handle to overheat.

Take care when frying food in hot oil or fat,

as the overheated splashes could easily

ignite.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

If the control knobs become difficult to turn, please

contact your local Service Force Centre.

Using the Wok Stand

A wok stand is provided to enable you to use a round

bottomed wok on the hob. The wok stand must only be

used on the front right burner, and should not be used

with any other type of wok or pan.

When fitting the wok stand, ensure the recesses in the

frame fit securely onto the bars of the pan supports, as

shown in the diagrams.

minimum

maximum

diameter

180 mm

260 mm

120 mm

220 mm

80 mm

160 mm

Triple-crown Burner

Fig. 1

A - Burner cap

B - Burner crown

C - Ignition electrode

suitable for model ZGF 682

suitable for model ZGF 692