Zanussi ZGG 642 Gebrauchsanweisung - Seite 12

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kochfeld Zanussi ZGG 642 herunter. Zanussi ZGG 642 20 Seiten. Gas hobs
Auch für Zanussi ZGG 642: Gebrauchsanweisung (16 seiten), Gebrauchsanweisung (16 seiten), Gebrauchsanweisung (20 seiten), Gebrauchsanweisung (16 seiten), Gebrauchsanweisung (16 seiten), Gebrauchsanweisung (16 seiten)

Seite drucken

ZGG 642

FO 2107

Electrical connections

Any electrical work required to install this hob

should be carried out by a qualified electrician or

competent person, in accordance with the current

regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability should these

safety measures not be observed.

This hob is designed to be connected to a 230 V 50

Hz AC electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the hob rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this book.

The hob is supplied with a 3 core flexible supply cord

incorporating a 3amp plug fitted. In the event of having to

change the fuse, a 3amp ASTA approved (BS 1362) fuse

must be used.

Should the plug need to be replaced for any reason, the

wires in the mains lead are coloured in accordance with

the following code:

Green and Yellow - Earth

Blue

- Neutral

Brown

- Live

— Connect the green and yellow (earth) wire to

the terminal in the plug which is marked with

the letter 'E' or the earth symbol

green and yellow.

— Connect the blue (neutral) wire to the terminal

in the plug which is marked with the letter 'N' or

coloured black.

— Connect the brown (live) wire to the terminal in

the plug which is marked with the letter 'L' or

coloured red.

Upon completion there must be no cut, or stray strands

of wire present and the cord clamp must be secure over

the outer sheath.

ZGG 782

Permanent Connection

In the case of a permanent connection, it is necessary

that you install a double pole switch between the hob

and the electricity supply (mains), with a minimum gap

of 3 mm. between the switch contacts and of a type

suitable for the required load in compliance with the

current electric regulations.

The switch must not break the yellow and green earth

cable at any point.

or coloured

FO 2321

a) Sealing gasket

A cut off plug inserted into a 13 amp socket is

a seriuos safety (shock) hazard. Ensure that

the cut off plug is disposed of safely.

Ensure that the hob supply cord does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

FO 0390