Zanussi ZGL640TW Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kochfeld Zanussi ZGL640TW herunter. Zanussi ZGL640TW 16 Seiten.
Auch für Zanussi ZGL640TW: Benutzerhandbuch (16 seiten)

Seite drucken

If after some tries the burner does not

light, check if the crown and its cap are in

correct positions.

A) Burner cap

B) Burner crown

C) Ignition candle

D) Thermocouple

Warning! Do not keep the control knob

pushed for more than 15 seconds.

Helpful hints and tips

Warning! Refer to the Safety chapters.

Energy savings

• If possible, always put the lids on the pans.

• When the liquid starts to boil, turn down the

flame to barely simmer the liquid.

Use cookware with diameters applicable to the

size of burners.

Burner

Rapid

Semi-rapid

Auxiliary

Warning! Make sure that the bottoms of

pots do not stand above the control

Diameters of cookware

180 - 260 mm

120 - 220 mm

80 - 160 mm

If the burner does not light after 15 seconds,

release the control knob, turn it into off position

and try to light the burner again after minimum

1 minute.

Important! In the absence of electricity you

can ignite the burner without electrical device;

in this case approach the burner with a flame,

push the relevant knob down and turn it

counter-clockwise to maximum gas release

position.

If the burner accidentally goes out, turn the

control knob to the off position and try to

light the burner again after minimum 1 minute.

The spark generator can start automatical-

ly when you switch on the mains, after in-

stallation or a power cut. It is normal.

Turning the burner off

To put the flame out, turn the knob to the sym-

bol

Warning! Always turn the flame down or

switch it off before you remove the pans

from the burner.

knobs. If the control knobs are under the

bottoms of pots, the flame heats them up.

Do not put the same pan on two burners.

Warning! Make sure that pot handles is

not above the front edge of the cooktop.

Make sure that pots are centrally put on the

rings in order to get maximum stability and to

get lower gas consumption.