Zanussi ZGM 782 ITX Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kochfeld Zanussi ZGM 782 ITX herunter. Zanussi ZGM 782 ITX 20 Seiten.

Seite drucken

Operation

Hob burners

To light a burner:

turn the relevant control knob anticlockwise to the

maximum position, then push it down to ignite the

burner;

upon ignition, keep the knob pushed down about 5

seconds. This will allow the "thermocouple" (Fig. 1,

D) to be heated and the safety device to be switched

off, otherwise the gas supply would be interrupted.

then, check the flame is regular and adjust it as

required.

If you cannot light the flame even after several attempts,

check the "cap" and "crown" (Fig. 1, A-B) are in the

correct position.

To put the flame out, turn the knob to the symbol

When switching on the mains, after installation or

a power cut, it is quite normal for the spark

generator to be activated automatically.

To ensure maximum burner efficiency, you should only

use pots and pans with a flat bottom fitting the size of

the burner used (see table).

Burner

Ultra-rapid

(triple-crown)

Large (rapid)

Medium (semi-rapid)

Small (auxiliary)

If you use a saucepan which is smaller than

the recommended size, the flame will spread

beyond the bottom of the vessel, causing the

handle to overheat.

Take care when frying food in hot oil or fat,

as the overheated splashes could easily ignite.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

If the control knobs become difficult to turn, please

contact your local Service Force Centre.

Do not keep the control knob pressed for more

than 15 seconds.

If the burner does not light even after 15 seconds,

release the control knob, turn it the "off" position

and wait for at least one minute before trying to

light the burner again.

Using the Wok Stand

A wok stand is provided to enable you to use a round

bottomed wok on the hob. The wok stand must only be

used on the central burner, and should not be used with

any other type of wok or pan. When fitting the wok stand,

ensure the recesses in the frame fit securely onto the

bars of the pan supports, as shown in figure 2.

minimum

maximum

diameter

180 mm

260 mm

180 mm

260 mm

120 mm

220 mm

80 mm

160 mm

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Triple-crown Burner

Fig. 1

Fig. 2