Zanussi ZBF22451SA Benutzerhandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Gefrierschrank Zanussi ZBF22451SA herunter. Zanussi ZBF22451SA 16 Seiten.
Auch für Zanussi ZBF22451SA: Benutzerhandbuch (16 seiten), Benutzerhandbuch (17 seiten), Benutzerhandbuch (16 seiten), Benutzerhandbuch (45 seiten)

Seite drucken

Ventilation requirements

The airflow behind the appliance must be

sufficient.

5 cm

min. 200cm

min.

200cm

Door reversibility

WARNING!

Before carrying out any operations,

remove the plug from the power

socket.

CAUTION!

To carry out the following

operations, we suggest that this be

made with another person that will

keep a firm hold on the doors of the

appliance during the operations.

1. Loosen the upper pin and remove the

spacer.

2. Remove the upper pin and the door.

3. Remove the door.

4. Loosen the lower pin.

5. Install the lower pin on the opposite side.

6. Install the door.

7. Tighten the spacer and tighten the upper

pin.

Do a final check to make sure that:

• All screws are tightened.

• The magnetic seal adheres to the

cabinet.

• The door opens and closes

correctly.

If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit

perfectly to the cabinet. In that case,

wait for the natural fitting of the

gasket.

In case you do not want to carry out

the above mentioned operations,

contact the nearest Authorised

Service Centre. The Authorised

Service specialist will carry out the

reversibility of the doors at your cost.

Installing the appliance

Make sure that the mains cable can move freely.

1. If necessary cut the adhesive sealing strip

and then apply it to the appliance as shown

in figure.

2. Drill the unit using a Ø 2.5 mm drill (10 mm

max. penetration), Fix the square fitting to

the appliance.

3. Push the appliance in the direction of the

arrows (1) until the upper gap cover stops

against the kitchen furniture.

4. Push the appliance in the direction of the

arrows (2) against the cupboard on the

opposite side of the hinge.

5. Make sure that the distance between the

appliance and the cupboard front-edge is

44 mm.

6. The lower hinge cover (in the accessories

bag) makes sure that the distance between

the appliance and the kitchen furniture is

correct.

7. Make sure that the clearance between the

appliance and the cupboard is 4 mm.

8. Open the door. Put the lower hinge cover in

position.

13mm

Ø 2,5