Zanussi ZFT11100XA Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Gefrierschrank Zanussi ZFT11100XA herunter. Zanussi ZFT11100XA 16 Seiten. Zanussi freezer user manual
Auch für Zanussi ZFT11100XA: Benutzerhandbuch (16 seiten)

Seite drucken

• It is advisable to wait at least four hours be-

fore connecting the appliance to allow the oil

to flow back in the compressor.

• Adequate air circulation should be around the

appliance, lacking this leads to overheating.

To achieve sufficient ventilation follow the in-

structions relevant to installation.

• Wherever possible the back of the product

should be against a wall to avoid touching or

catching warm parts (compressor, condens-

er) to prevent possible burn.

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

• Connect to potable water supply only (If a

water connection is foreseen).

Service

• Any electrical work required to do the servic-

ing of the appliance should be carried out by

a qualified electrician or competent person.

Control panel

Green Indicator Light

Red Indicator Light

Temperature Regulator

Half Loaded position

Full Loaded position

Switching on

1. Allow the appliance to stand for 4 hours af-

ter installation.

2. Insert the plug into the wall socket.

3. Turn the Temperature Regulator clockwise

to the Full Loaded position.

• This product must be serviced by an author-

ized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses

which could damage the ozone layer, in ei-

ther its refrigerant circuit or insulation materials.

The appliance shall not be discarded together

with the urban refuse and rubbish. The insula-

tion foam contains flammable gases: the appli-

ance shall be disposed according to the appli-

cable regulations to obtain from your local au-

thorities. Avoid damaging the cooling unit, espe-

cially at the rear near the heat exchanger. The

materials used on this appliance marked by the

symbol

are recyclable.

4. The Green Indicator Light will light up and

remain lit until the appliance is switched off

at the mains.

5. Leave to run for 4 hours to allow the correct

temperature to be reached before placing

food inside.

Yellow Indicator Light lights in the switch-

ed-on state of the Freezer Switch.

6. The Red Indicator Light will also illuminate

until the correct temperature is reached.

A few hours after starting up the Red Indi-

cator Light will go out to show that the cor-

rect temperature has been reached for the