Zanussi ZFT810FW Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Gefrierschrank Zanussi ZFT810FW herunter. Zanussi ZFT810FW 16 Seiten.

Seite drucken

immediately to the place you bought it. In that

case retain packing.

• It is advisable to wait at least four hours be-

fore connecting the appliance to allow the oil

to flow back in the compressor.

• Adequate air circulation should be around

the appliance, lacking this leads to overheat-

ing. To achieve sufficient ventilation follow

the instructions relevant to installation.

• Wherever possible the back of the product

should be against a wall to avoid touching or

catching warm parts (compressor, condens-

er) to prevent possible burn.

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

• Connect to potable water supply only (If a

water connection is foreseen).

Service

• Any electrical work required to do the servic-

ing of the appliance should be carried out by

a qualified electrician or competent person.

Control panel

Green On/Off Indicator Light

Temperature Regulator and On/Off Switch

Yellow Fast Freeze Indicator Light

Acoustic Signal Stop and Fast Freeze

Switch

Red Alarm Indicator Light

Switching on

1. Allow the appliance to stand for 4 hrs after

installation.

2. Insert the plug into the wall socket.

• This product must be serviced by an author-

ized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses

which could damage the ozone layer, in ei-

ther its refrigerant circuit or insulation materials.

The appliance shall not be discarded together

with the urban refuse and rubbish. The insula-

tion foam contains flammable gases: the appli-

ance shall be disposed according to the appli-

cable regulations to obtain from your local au-

thorities. Avoid damaging the cooling unit, es-

pecially at the rear near the heat exchanger.

The materials used on this appliance marked by

the symbol

3. Turn the Temperature Regulator clockwise

to a temperature lower than << - 16 °C

>> position.

4. The Green On/Off Indicator Light will light

up and Red Alarm Indicator Light will blink.

5. The lighting up of the Green On/Off Indi-

cator Light means that the appliance is

switched on.

6. The blinking of the Red Alarm Indicator

Light means an improper temperature in

the freezing compartment. In addition, an

intermittent sound can be heard, which can

are recyclable.